NANDROMIX-300 300mg/ml NPP,DECA Finsihed Oil

NANDROMIX-300 300mg/ml NPP,DECA Finsihed Oil
Product Introduction:
NANDROMIX-300 is a blend of several nandrolone esters that synergistically enhances protein synthesis and nitrogen retention, increasing muscle mass and strength. Its ability to boost collagen synthesis enhances joint and tendon health. It is used medically for rehabilitation of wasting diseases and in the fitness field for muscle growth and joint maintenance, delivering comprehensive benefits.
Send Inquiry
Description
Technical Parameters

NANDROMIX -300 (Nandrolone Decanoate Complex) 300mg/ml Core Introduction

Pharmaceutical -grade injection | Nandrolone Blend (High-concentration Polyester Anabolic Steroid Mix)

Combination formula :

Nandrolone Decanoate : 150mg/ml

Nandrolone Phenylpropionate : 150mg/ml

Total concentration : 300mg/ml

Solvent : Cottonseed oil/Sesame oil + Benzyl alcohol (2%)

Appearance : Transparent light yellow oily liquid


Core Effects

NANDROMIX-300 is a high-concentration multi-ester blend that uses a precise ratio of long-acting and short-acting esters to achieve the triple advantages of rapid onset, smooth transition, and long-lasting stability . It is suitable for muscle-building cycles, improving joint health, and enhancing athletic performance .

✅ ​Biphasic release advantages :

Phenylpropionate (fast-acting) : Short-acting release (2-3 day half-life), rapid buildup of blood concentrations

Decanoate (long-acting) : long-acting sustained release (15-day half-life), maintaining long-term stable effect

✅ ​Powerful muscle building :

Promote protein synthesis , and increase muscle mass by 10-15kg in 12-16 weeks

Significantly improve strength levels and break through training bottlenecks

✅ ​Joint health improvement :

Promote the secretion of synovial fluid in joints and relieve joint pain caused by training

Enhance connective tissue strength and reduce the risk of sports injuries

✅ ​Low androgenic properties :

Low androgenic activity (androgenic index 37), with minimal risk of side effects

Does not convert into DHT , no risk of hair loss and prostate hyperplasia


End Product Preparation Guidelines

1. Preparation of compound injection oil (300mg/ml) :

Recipe example (preparation volume for 100ml):

Nandrolone decanoate raw material: 15.0g

Nandrolone phenylpropionate raw material: 15.0g

Benzyl alcohol: 2.0ml

Cottonseed oil: add to 100ml

Preparation process :

Raw material pretreatment : micronization (D90≤5μm)

Step -by-step dissolution :

First dissolve nandrolone phenylpropionate (40°C water bath, magnetic stirring)

Add nandrolone decanoate and stir until completely dissolved

Oil replenishment and mixing : Add the remaining oil phase and continue stirring for 40 minutes

Sterile Filtration :

Pre-filtration: 1.0μm filter membrane to remove large particles

Final filtration: 0.22μm PES membrane positive pressure filtration

Subpackaging : Subpackaging into sterile injection bottles under aseptic environment

Quality Control :

HPLC assay :

Nandrolone decanoate: 95-105% labeled amount (142.5-157.5 mg/ml)

Nandrolone phenylpropionate: 95-105% labeled amount (142.5-157.5 mg/ml)

Endotoxin detection : <0.5EU/ml

Sterility test : 14 days of culture by membrane filtration

2. Preparation Notes :

Dissolution order : Dissolve in descending order of solubility (phenylpropionate → decanoate)

Temperature control : 40-45°C water bath to avoid high temperature degradation

Stirring speed : 200-300 rpm to ensure complete dissolution

Filtration pressure : positive pressure filtration, pressure ≤ 0.3MPa


Usage Protocol

1. Bulking Cycle :

Dosage : 300-600 mg/week, deep intramuscular injection

Duration : 12-16 weeks

Results : Increased lean body mass by 10-15kg and significantly improved strength

2. Improved joint health :

Dosage : 200-400 mg/week, deep intramuscular injection

Cycle : Long-term use

Effect : Joint pain is significantly relieved and exercise comfort is improved

3. Improved athletic performance :

Dosage : 400-800 mg/week, deep intramuscular injection

Duration : 8-12 weeks

Effect : Increased endurance and faster recovery

4. Injection technique :

Injection route : Deep intramuscular injection

Injection site :

Gluteus maximus : preferred site, stable absorption

Deltoid muscle : Secondary site, easy to operate

Needle Selection :

Gluteal injection : 23G 1.5-inch needle

Deltoid injection : 25G 1-inch needle

Injection frequency : 2 times a week (fast and slow ester binding to maintain stable blood drug concentration)

5. Injection steps :

Preparation before injection :

Wash your hands and prepare alcohol pads, needles, and syringes

Warm the vial to 37°C (hold in the palm of your hand for 2 minutes)

Drug extraction operation :

Sterilize the rubber stopper and inject an equal amount of air

Slowly draw out the required dose, removing any air bubbles.

Injection procedure :

Disinfect the injection site (5 cm diameter circle)

Rapidly advance the needle 90 degrees and slowly push the needle in (30 seconds/ml)

After removing the needle, press the cotton pad and do not massage the injection site


Lifecycle Support and Management

Mid- cycle support ​:

Antiestrogens :

Exemestane 12.5 mg every other day (adjusted based on estrogen symptoms)

Cardiovascular protection :

Fish oil 3g/day

Coenzyme Q10 200 mg/day

Prostate protection : Saw palmetto extract 320mg/day

PCT Requirements ​:

Start time : 3 weeks after the last injection (decanoate has a long half-life)

Solution :

Tamoxifen: 20 mg/day for 4 weeks → 10 mg/day for 2 weeks

Clomiphene: 50 mg/day for 2 weeks → 25 mg/day for 2 weeks


Why choose NANDROMIX-300 ?

Dual ester complex formula achieves a perfect balance of fast and slow effects

Powerful muscle building and joint protection , comprehensively improving athletic performance

Stable blood drug concentration , avoiding mood and physical fluctuations


Quality Assurance :

GMP compliant production , aseptic filling process

Third-party laboratory testing (dual HPLC assay)

Endotoxin detection (<0.5EU/ml)

Worldwide Shipping :

Medical multi-dose bottle packaging

Private delivery , no logo on the outer packaging

Temperature- stable transportation to ensure product stability


Conclusion

NANDROMIX-300 is manufactured through precise formulation and aseptic processing , making it particularly suitable for muscle-building cycles, improving joint health, and enhancing athletic performance . The recommended dose is 300-600mg/week .

Need a specific usage plan ?

We provide professional medication guidance to help you achieve your goals safely and efficiently!


Need anything, please contact us

WhatsApp

+852 4671 8216

Telegram

Allenraws

Email

Allenraws810@gmail.com

product-1268-769

 

Hot Tags: nandromix-300 300mg/ml npp,deca finsihed oil, China nandromix-300 300mg/ml npp,deca finsihed oil manufacturers, suppliers, factory, Masteron Drostanolone Propionate, la stanozolol, spl stanozolol, Sustan 250 Mass Building Strength Boost, drostanolone for sale, Drostanolone Prop And Masteron

Send Inquiry
contact us